The Most Common Drywall Issues And FixesPosted by: admin | Posted on: October 3, 2019
When it comes to handyman drywall repair, there are some issues you need to know how to fix properly or you will end up paying more to have a professional repair the faulty repairs you made in the first place. If you don’t know the right drywall repair tips before you tackle any drywall issue, you are only wasting more time and money.
So don’t screw this up. Know the most common drywall problems and how to fix them right, the first time. Without this knowledge, you’re just going to do more damage in the long run.
Drywall Screws Have Been Driven Too Deep
When your drywall screws or nails get driven too far into the drywall, it can damage the surface paper of the wallboard. It may seem like no big deal, but this is a real problem. If the paper face becomes torn or damaged, that greatly reduces the holding power of the screw or nail.
The way to fix or avoid this problem from happening is to be careful about driving the head of the nail or the screw so that it is exactly level with the surface of the paper. Then slowly and carefully, drive the nail or screw to just drop below the surface. If you fail and tear the paper, don’t worry, you can drive another nail or screw next to the one you drove too far. This is perfectly feasible as a fix.
Drywall Joints Installed Too Tightly
If two of your drywall sheets are attached in adjoining fashion be sure they aren’t fit too tightly against one another side by side. This could damage the drywall in a variety of ways. Expansion and contraction of the framing as well as the drywall sheets being squeezed against one another are just two of the hazards you need to watch out for.
The solution here lies in the installation process. Always keep a space of 1/8 inch between the sheets. Place them any closer and it’ll be tough to rectify the problem once they’ve been installed.
Paper Has Been Oversanded
Another potential common issue where the drywall paper is concerned, it can be possible and all too easy to oversand the drywall paper, jeopardizing the installation of your drywall sheets. If you go too far you risk sanding into the paper and fiberglass tape installed to cover the seams. You may even sand into surface of the surrounding drywall. All of these things can make your project vulnerable to damage and could require repairs or even replacement.
The best solution to the problem is to use a light, positioned at a low angle at the wall you are sanding. This will give you a much better view on what you are trying to accomplish so you can avoid getting too crazy with your sanding job.
These are just some of the drywall issues that exist, but if you follow these helpful hints you can avoid the biggest mistakes that are made by homeowners just like you.